![]() The settings that you select in the Add Sensor dialog are valid for all sensors that you create when you finish the dialog. You can change nearly all settings on the sensor's Settings tab after creation. It only shows the settings that are required to create the sensor. The Add Sensor dialog appears when you manually add a new sensor to a device. For Gen10 servers, use the HPE iLO interface as parent device for this sensor. You can set this up in the iLO configuration interface under Administration | Management | SNMP Settings. We recommend that you use the Agentless Management feature with configured SNMP. If this sensor throws an error that it cannot find "such device types", create a device that points to the address of the HPE iLO interface (if available) and add the sensor to this device. Instead, the sensor needs the HPE Agentless Management Service to be installed on the target device.įor more details and download links, see the Knowledge Base: Monitor HP ProLiant via SNMP?įor Gen9 servers or earlier, some of the HPE object identifiers (OID) that this sensor uses are only accessible via the iLO interface. For Gen10 servers, this sensor no longer requires HPE system management tools. To receive SNMP data from redundant array of independent disks (RAID) controllers, you additionally need HPE Insight Management Agents. įor Gen9 servers or earlier, this sensor needs a specific HPE system management tool to be installed on the target device to report data via SNMP: HPE Insight Management Agents. You can change the behavior of a channel by editing the lookup file that the channel uses. This means that possible states are defined in a lookup file. This sensor uses lookups to determine the status values of one or more channels.This sensor has a low performance impact.This sensor supports the IPv6 protocol.We recommend that you use iLO 4 or later. This sensor supports monitoring iLO as of iLO version 3.For more information, see SNMP HPE ProLiant Physical Disk sensor not showing all information. The sensor only shows Disk Status and no other channels if it runs in "Limited Monitoring" mode.For Gen10 servers: Use the HPE Integrated Lights Out (iLO) interface as the parent device for this sensor.For Gen10 servers: This sensor requires HPE Agentless Management and the HPE Agentless Management Service to be installed on the target device.For Gen9 servers or earlier: This sensor requires HPE Insight Management Agents and HPE Insight Management WBEM Providers to be installed on the target device.Spanish : Disco físico HPE ProLiant (SNMP).Simplified Chinese : SNMP HPE ProLiant 物理磁盘.Portuguese : Disco físico HPE ProLiant (SNMP).German : SNMP HPE ProLiant Physikalischer Datenträger.French : HPE ProLiant disque physique (SNMP).Dutch : SNMP HPE ProLiant Fysieke Schijf.For a detailed list and descriptions of the channels that this sensor can show, see section Channel List.
0 Comments
Leave a Reply. |